How to modify the speed and duplex settings on a SnapServer

Version 1

    How to modify the speed and duplex settings on a SnapServer

     

    This information is not Operating System specific

     

    ---Solution---

     

    By default, the Ethernet settings on all SnapServers are configured for auto sense. If it is necessary to modify the settings to accommodate specific network requirements, the steps below are available for Snap OS servers running 3.x software or higher.


    1. Point the browser to the http://nameorIPofyourSNAPServer/config/debug page.<


    2. A command box should be displayed.


    3. The commands available to modify the settings are as follows.<br>et sp 10 = to set speed to 10<br>et sp 100 = to set speed to 100<br>et sp 0 = to set speed to auto negotiate<br>et fu en = to enable full duplex<br>et fu di = to disable full duplex


    4. Keep in mind the port settings of the switch must match those of the adapter. For changes to take effect, reboot the Snapserver.


    Link not valid