How to start/stop web service daemon on SnapServer

Version 1

    The SnapServer is functioning as expected, however the web administration interface is not working. Is it possible to restart the web service daemon without restarting the SnapServer?

    This information applies to the following Product(s):

    - SnapServer 4200
    - SnapServer 4400
    - SnapServer 4500
    - SnapServer 14000
    - SnapServer 15000
    - SnapServer 18000

    This information applies to the following Operating System(s):

    - This information is not Operating System specific


    Yes, you can start/stop the web service daemon using SSH.

    In SSH you can find the http daemon in the following directory:


    Then depending on your needs you can type: httpd stop or httpd start