Not able to see the Recovery Console page after perform the touch /nopivot

Version 1

    After the touch /nopivot command and a reboot, the Recovery Console page does not come up.

    This information applies to the following Product(s):

    - SnapServer 4200

    - SnapServer 4400
    - SnapServer 4500
    - SnapServer 14000
    - SnapServer 15000
    - SnapServer 18000

    This information applies to the following Operating System(s):

    - This information is not Operating System specific


    ---Solution---

    When the Snap server is in recovery console mode the default gateway is not specified. Enter the command below from the serial console to add the default gateway to the Snap server and recovery console page should load up afterward:

    route add default gw